iLLustrator Videos Tutorials : Watching: Pinz efi warmstart then redline while still in warmup mode
Video scenes shots:

Watch the video:
Advertisment :
Other videos by this author:
![]() |
pinz_coldstart27deg.MOV Posted by: pinztrek
Video duration: 54 seconds Pinzgauer cold start & drive off test at 27f degrees. Vehicle is Stock Swiss Pinz 710 with EFI Related: efi, pinzgauer, pinztrek |
![]() |
Pinzgauer Fuel Injection hot starts & rev limiter Posted by: pinztrek
Video duration: 89 seconds Repetitive hot start testing of fuel injected pinzgauer Toward the end of the video you can see it bouncing against the rev limiter This was fairly early in our tuning, it's even smoother starts now with proper enrichment down to below freezing. Turn the key, it starts, and drive away! No choke, no warmup, no flooding like carbs did. Related: efi, fuel, injection, krois, pinz, pinzefi, pinzgauer, pinztrek |
![]() |
Pinzgauer EFI idling up a 25 degree slope with no drop in idlespeed Posted by: pinztrek
Video duration: 58 seconds Pinzgauer EFI idling up a 25 degree plus hill with no drop in idlespeed, etc. This is due to closed loop idle control. Will try to reshoot with view of gauges, and throttle position. It will happily idle up steeper, this is just what I had in my front yard. More to come Related: efi, pinz, pinzgauer, pinztrek |
![]() |
Pinz EFI- Warmstart then redline while still in warmup mode Posted by: pinztrek
Video duration: 84 seconds Warmstart on 38 degree day. Still in warmup mode with some fast idle & warmup enrichment. Then I take it to redline, you can see it bump against the rev limiter at 4550. (Don't try this at home boys & girls!) Intent is to show throttle response at higher RPM's while still in warmup mode. Harder than you think to achieve! Related: efi, pinz, pinzgauer, pinztrek |
![]() |
ALE RTTY Busy Channel Detection demo Posted by: pinztrek
Video duration: 38 seconds 1st attempt with signal present fails- Indicator in lower left shows "LISTEN CHANNEL", then immediately fails with "STOPPING" due to busy channel detection. Cut back on RF gain so no signal is present. Transmits after "LISTEN CHANNEL" with "CALLING" indicator Third attempt with signal again fails immediately after LISTEN CHANNEL Related: ale, radio, rtty |
![]() |
ALE Busy Channel Detection Demo SSB Net Posted by: pinztrek
Video duration: 56 seconds Demo with SSB net 1st attempt with signal present fails- Indicator in lower left shows "LISTEN CHANNEL", then immediately fails with "STOPPING" due to busy channel detection. Cut back on RF gain so no signal is present. Transmits after "LISTEN CHANNEL" with "CALLING" indicator Third attempt with signal again fails immediately after LISTEN CHANNEL Related: ale, radio |
![]() |
Pinz EFI- repeated warm starts at 38 degrees Posted by: pinztrek
Video duration: 53 seconds Repeated warm starts on at 38 degrees. Engine still not fully warmed up, still has some fast idle air and warmup enrichment. You can hear my worn out starter drag on a couple of these, that's my 35 year old truck, not the EFI. Related: efi, pinz, pinzgauer, pinztrek |






